As of this writing, the latest version is NTFS-3G 2009.4. As you would locate the connected Mac drive, you can view a Not Initialized message adjacent to it. It looks like they are releasing a paid version called Tuxera NTFS, but NTFS-3G is still available. Step 3: Convert an Apple Hard Drive to Windows NTFS Format Once you have wiped the existing data on the connected APFS hard drive, you can again launch the Disk Management application.
The direct link for the free version of NTFS-3G is down on his blog a little bit. I've usually tried to always remove external drives with that method, so that doesn't really change anything for me. The only "gotcha" that I've ran across so far is that you need to "Safely Eject this Hardware" from within Windows or you'll get a complaint by NTFS-3G about data integrity. Step 3: Click on 'Format' and select 'exFAT' from the 'File System' list. Step 2: In the explorer look for your USB flash drive and right-click on it.
I've also taken the drive and presented it to my Windows 7 machine and it worked great on there too. Using File Explorer, you can format the flash drive from 'FAT32' to 'exFAT' easily and effectively following the below steps: Step 1: Open File Explorer by pressing 'Windows' + 'E' keys. I copied over 85GB of data to my brand new 500GB external drive, which is formatted with NTFS and everything seems to be working like a champ. Performance in my very simple file transfer tests seemed right on with Paragon's test results. After a reboot, I was able to read/write to my NTFS drives, and without paying anything. I removed Paragon from the system and installed NTFS-3G. NTFS-3G was referred as a Paragon alternative without the cost. Yet, I ran across the other solution on a blog, which is free.
At only $19.95 (Fall Special right now), it didn't seem like that bad of an option. I was able to now read and write to my NTFS formatted external drives.
Paragon looked like it would work great so I downloaded and installed the trial version off their website. I ran across basically 2 solutions that you can use for this. It's a great filesystem and I figured if I could get my Mac to beable to read and write a NTFS filesystem, that would work great.
Type your admin password and press Return when prompted.Enter the following command and press Return: sudo nano /etc/fstab.Launch Terminal with the NTFS drive connected to your Mac.Under the Format field, select the MS-DOS (FAT) and Master Boot Record for the Scheme field. Choose the USB drive from the side and select the Erase. Go to Applications > Utilities > Double-click on the Disk Utility. If you understand the risks and wish to enable NTFS write mode in macOS, you can do so by following these steps: Connect the NTFS USB drive to a Mac computer. Therefore, you should proceed with caution. In this case, enabling a setting that affects disk write capabilities has the potential to corrupt hard drives and cause data loss. Format exFAT to NTFS through File Explorer On File Explorer, find and select your USB drive. Whenever you make any significant changes to your system, you should always back up important information first. The feature is somewhat experimental-or, at the very least, unsupported by Apple-so the results can be unpredictable. To enable the tool, you’ll need to use Terminal, and you do so at your own risk. Interestingly, macOS does have the ability to write to NTFS, but Apple disables the feature by default.